custom carpc bezel feeler for 3rd gen 4runners

[Seanz0rz]

so i wanted to post here and gauge interest in a custom developed carpc bezel for 3rd gen 4runners.

it would be very similar to the one i am constructing currently.

here it is in its current form lacking paint and final touches:

http://i103.photobucket.com/albums/m141/hamiltoncomputers/DSC02027.jpg


what would you be willing to pay for this bezel, with out screen? screens cost in the neighborhood of $300.

[Seanz0rz]

so im taking the lack of response as a no.

[Erich_870]

It sounds cool. Did you use an old one for your prototype, or do you not mind bondo in the buttons :P

You mentioned sprucing it up around the opening, so I assume you'll bend it so it has the same look as the clock and button locations.

Does the CarPC attach to the bezel or the stock mounting points for the stereo? Just wondering.

Erich

[Seanz0rz]

im trying to keep bondo out of the buttons! im using my center console section from my truck and the actual bezel that came with the screen, no extra parts here.

i had to remove the stock location for the hvac controls, and i am moving them below the radio, where the ash tray and power points once were. to do that im having to extend the hvac mechanical lines. but that process is for http://www.ultimateyota.com/index.php?option=com_smf&Itemid=26&topic=1120.0] (http://"[url) this[/url] thread...

as for making it look stock, i dont think i can do that. its just far too difficult. but i am going to try and make it look professionally done, and make it look like it was manufactured.

im thinking for the ease of installation for the average user, i would locate the screen lower to the double din slot. and then move the headunit lower. this way the hvac controls are not tampered with.