Spindle nut

[91_4x4runner]

I recently repacked by bearings and when I pulled off the spindle nuts, they were barely hand tight on the truck... I used the "touchy feely" method of cranking them suckers back on there, but what is the rated amount to torque them to? Thanks, Eric.

[waskillywabbit]

The touchy feely method won't get it...find an online FSM and do it right or you just wasted your time and some money in the future.

:guitar:

[GSGALLANT]

To properly set the preload on your bearings, see the steps in the FSM here. (http://www.the-roo.com/4runner/Suspension/frontaxl.pdf)