northwest off road used to offer a diamond plate rocker panel for 4runner

[swerks]

Any one know if these are available any where???? :thumbup:

[swerks]

Northwest no longer carries these

[MTL_4runner]

Hey swerks, what's going on with your avatar being MIA?

[swerks]

Im working on the avitar but I am at my work now

[cootees]

never seen it before. Any pics of what it looked like?

[swerks]

http://img230.imageshack.us/img230/5720/rockermediumbo5.jpg
heres your pic.

[swerks]

One last bump: any info please????

[slosurfer]

I bet you could have them made if no one is selling them.

[swerks]

any one know where I could have something like this made???? :thumbup:

[Trustyrusty]

In your driveway.. :lol:

Got Welder?

[swerks]

no welder, no skill in that area

[Trustyrusty]

Hmmm, If I were you, I'd learn! And get a cheap little tig welder or something like that at harbor freight, other than that, to have it made. Diamond plate is getting expensive, and you should just get sliders instead of getting those ugly, rust causing, mall crawler panels. :thumbup:

[Erich_870]

Hmmm, If I were you, I'd learn! And get a cheap little tig welder or something like that at harbor freight, other than that, to have it made. Diamond plate is getting expensive, and you should just get sliders instead of getting those ugly, rust causing, mall crawler panels. :thumbup:


Trustyrusty does have a couple good points. They will eventually allow rust to form out of sight, so you won't know until it's too late. They also wont save your sheet metal like sliders.

That being said, you could talk to a local welding/fab shop and find one with a metal break. It would take a pretty big one to bend diamond plate, but it's not unheard of. I would make a card board template of the panel and one of how you want it bent to fit the bottom of your door. Take those with you, plus the pic and see what they say.

Erich