blown engine in my dirt bike

[GOLDS]

hey, just wondering if anybody has a line on a engine for my bike. Its a 1999 Honda CR 125 and I just need a bottom end. I was riding about a month ago, full throttle, 2nd gear and it was the loudest bang I have ever heard from an engine. When I disassemble it the con rod snapped right at the crank end bearing, then the rod cracked the case and the piston hit the head and bent the head :(. I allready found a new head, but I still need a bottom end

Oh well, just more fubared parts to add to my wall of shame.

[MTL_4runner]

I'd be trolling eBay for something like that.

[GOLDS]

I have been looking there , they are selling for more than I want to spend right now...

[MTL_4runner]

I have been looking there , they are selling for more than I want to spend right now...


Hmmmm....can you get your old case rewelded? or is it an acutal hole in the side of the block?

[GOLDS]

It could be rewelded, but I want to go the used route because my crank is bent, and
I would also need new bottom end bearings, so the cost will be about equal. then I will have a parts engine as well.

Also, I suspect that there might be damage to the case that I can't see, warped?