L33T35T Tacoma
09-02-2007, 07:17 PM
So i have a very bad water leak at the number 2 idler pulley. I am tearing in to it and i see my cams like this. I think the factory marks on the plate behind the cams are above the bolt holes. It doesnt exactly line up on either one. The engine runs smooth but gets poor gas mileage. Is this of any concern?
Note: I PUT THE MARKS ON THE TIMING BELT
Crank at TDC
http://i31.photobucket.com/albums/c357/jlboggs/timing1.jpg
Passenger side cam
http://i31.photobucket.com/albums/c357/jlboggs/timing2.jpg
Driver side cam
http://i31.photobucket.com/albums/c357/jlboggs/timing3.jpg
Note: I PUT THE MARKS ON THE TIMING BELT
Crank at TDC
http://i31.photobucket.com/albums/c357/jlboggs/timing1.jpg
Passenger side cam
http://i31.photobucket.com/albums/c357/jlboggs/timing2.jpg
Driver side cam
http://i31.photobucket.com/albums/c357/jlboggs/timing3.jpg