Should i be concerned? 3vze timing

[L33T35T Tacoma]

So i have a very bad water leak at the number 2 idler pulley. I am tearing in to it and i see my cams like this. I think the factory marks on the plate behind the cams are above the bolt holes. It doesnt exactly line up on either one. The engine runs smooth but gets poor gas mileage. Is this of any concern?

Note: I PUT THE MARKS ON THE TIMING BELT

Crank at TDC
http://i31.photobucket.com/albums/c357/jlboggs/timing1.jpg

Passenger side cam
http://i31.photobucket.com/albums/c357/jlboggs/timing2.jpg

Driver side cam
http://i31.photobucket.com/albums/c357/jlboggs/timing3.jpg

[reggie 00]

Looks like your off 1 tooth.

had to double check myself.
http://personal.utulsa.edu/~nathan-buchanan/93fsm/engine/67timingbe.pdf
page EG2-43

[DHC6twinotter]

Yup, I agree with reggie. Looks like you're off a tooth. Just lign it up with the indentions on the timing backing plate (or whatever that is called).

[MTL_4runner]

I'd agree that your belt is off by 1-2 teeth which could definately cause poor performance and bad gas mileage.