3rd Gen rear bumper replacement

[ttora4runner]

Around April of this year I had gotten my 4runner into a bad spot while out wheeling (by myself, stupid I know :chair:). I paniced and attempted to back out and damaged the left hand portion of my rear bumper. Had I gone straight (which I did though a v-type opening)it wouldn't have happened.

Any how I can possible get the parts from a member over at Yotatech to replace the damaged section but I'm not quite sure that I want to do that as of yet. It's probable going to get damaged again anyways and I don't know if I want to spend the money and then damage a another bumper (then again I don't get out wheeling as much as I would like). If I can hold off for awhile I might try to get a custom rear bumper.

So I'm just seeing what you guys think. Go ahead and get the replacement panels for my bumper or just wait for awhile and get a custom rear bumper (might look a little funny with no lift though).

[ravencr]

Do it right the first time! Save your money and get an aftermarket replacement.

Chris

[Seanz0rz]

personally, just leave it until you swap in a new bumper. i dented my left wing at school (offroading between the parkinglots!) and then again up on holcomb creek. as far as im concerned, its sheetmetal that can be unbolted and pounded out or replaced, therefore its expendable.