1984 4Runner Parts Request.

[04 Rocko Taco]

Hey guys. I'm doing a transmission replacement on my '84 22R 5 speed runner.

The parts I need are:

Driveshaft Bolts. I am not sure on the thread pitch for these things, but you guys should be able to look it up. I know they have 12mm heads with 14 mm nuts. I need 16 of them, I plan on replacing all of mine.

I also need some grease fittings for the U-joints on the driveshafts (front and rear) again not sure how many of these there are, but you guys tell me. Thanks! I'll check back later.

[RAFA@NTP]

I will look into this and let you know A.S.A.P :thumbup:

[RAFA@NTP]

pm sent!

[04 Rocko Taco]

Thanks for the earlier PM Rafa.

Here is a final count of what I need part numbers and a qoute on.

Driveshaft Bolt X 1
Grease Fitting X 1 (For the center bearing end of the front d-shaft, pictured below)
(These appear to be the same grease fitting, but one is broken off)
http://i86.photobucket.com/albums/k112/04RockoTaco/Tracy/DSCF8450.jpg
Throwout Bearing X 1
Pilot Bearing X 1
Clutch Disc X 1
Pressure Plate X 1
Pressure Plate Bolt Set X 1 ( 6 bolts )

[RAFA@NTP]

ok, I will look them up :thumbup:

[04 Rocko Taco]

Find anything Rafa?