Barter CAD CAM program for Rear Axle / Wheel Bearing Removal Tool "SST"

[foggysps]

Basically need this pictured below and am willing to trade a fresh working copy of an expensive CAD CAM program.
http://128.83.80.200/TACO/rwb10.jpg
http://128.83.80.200/TACO/rwb11.jpg
http://128.83.80.200/TACO/rwb12.jpg
http://128.83.80.200/TACO/rwb13.jpg

[4runnerchevy]

Just make the tool and be done with it. :thumbup:

[Cebby]

What program? If it's something I need, I'll whip one up for you.

[foggysps]

Cebby, It is Mastercam 9 which has Lathe, Design, Mill, Router, Wire virtual toolpath verification, and CNC tooling capabilities to name a few features.
Here is a link showing all that it is capapble of. http://www.shopwareinc.com/pages/v9.html
This is a full working EDU version with License and is $15,000 to 20,000 to purchase

I would make my own SST, but there are 2 problems.
1st I don't know how to weld good
2nd I don't have the metal stock
2nd I don't have a spare axle housing

[BruceTS]

Where are you located?

I can make one up in a heart beat.....

[foggysps]

I am located in Westport, MA

[BruceTS]

Dang on the wrong coast........ if you lived closer, I would have made one for you for the cost of the material. Have a few axle housings just sitting around. Was planning on making one for myself, so I could easily used the other half of the housing for a second..

[foggysps]

I'll definitely pay for shipping an handling....
I need 1 bad
My 4runner is laid up in a borrowed garage and I am going on week 3 of a rental car