PDA

View Full Version : Almost new 31" BFG ATs



strykersd
09-29-2008, 07:56 PM
These are 31X10.5X15 BFG All Terrains with only 700 miles on them. I payed $650 for them last month but am now bumping up to 33X10.5s. I'll sell them for $500 for tires only or $500 and trade me your stock alloys. They're mounted on 15" tacoma wheels. I'll even throw in 3 extra BFG 31" ATs with probably 10-15% life left as spares. Located in San Diego, CA. Let me know

Check my sig for pics of the wheels.

waskillywabbit
10-05-2008, 03:55 PM
Wish you were on this coast.

:D

chrisyota65
10-07-2008, 02:55 AM
hey patrick dont got with a 33x10.50. go with the 33x12.50 so it will be a little wider and you will get more traction and more bit to. also got the truck fixed.

04 Rocko Taco
10-07-2008, 07:55 PM
Actually depending on your lift, and aims for the suspension, then the 10.5's may be a lot better, there are a lot of guys out there running 33X9.50's although those are hard to come across. a lot of guys swear by thier 'pizza cutters'.

chrisyota65
10-07-2008, 11:58 PM
i prefere the 33x12.50 way better

strykersd
10-08-2008, 09:54 AM
Update: The tires have been sold

Hey Chris, congrats on getting the truck up and running again. Have you hit up any trails yet?

I ended up just going with the 33X10.5's for a few reasons
-less time airing up
-less stress on steering components
-fits on my stock rims
-still tucks into my rear fender when fully stuffed (keep in mind I have 2" wheel spacers)

chrisyota65
10-08-2008, 05:52 PM
my tires dont have any backspacing, but the do tuck under my rear fenders a little. no have not to it on much trails yet but i went driving around on some hills today.

slosurfer
10-08-2008, 06:55 PM
my tires dont have any backspacing, ....


If your rims didn't have any backspacing, your tires would be sticking way,way out. :laugh:

04 Rocko Taco
10-08-2008, 07:42 PM
0 backspacing is the "mexican" (pardon my racial profiling) look. you know where the tires stick way out from under the car, backspacing is the measurement (in inches) from the inside lip of your wheel to the inner hub mating surface (the inside of the center of the wheel where the lugnuts go). Most toyota's with 33 (especially 12.50's) need 3.5-4" of backspacing.

slosurfer
10-08-2008, 08:51 PM
Generally seen on dodge neons with gold trim. :laugh: