94 toyota pickup

[NY94PK]

Anybody kno how to swa :confused:p in a 1uzfe engine into a 94 toyota pickup 5speed 4x4

[slosurfer]

unpossible

[DHC6twinotter]

Welcome to the forum!

You'd have to buy a bellhousing from Australia or make your own. Dellows and CRS are the two companies down there that sell the kit (Dellows being the better one, imho). I've been out of the loop, and there may be other companies making adapter now as well.

I've also seen people make their own bellhousings by welding two halves together, or modifying the A340 bellhousing with a thin adapter plate.

Another option is to import an H150/151 tranny out of a 2uz equipped Land Cruiser and figure out what to do about the offset rear output on the t-case. Many of the H151/H150 transmissions use the same split t-case that is behind other Land Cruiser transmissions, so Marlin Crawler may have a solution for this. Not sure.

Wiring would be the hardest part. Unless you plan on using a stand alone ECU, you may be able to use the ECU out of a Toyota Crown.

Some good reading:
http://forum.ih8mud.com/70-series-tech/64321-4-0l-v8-1uz-fe-land-cruiser-uzj79.html

www.lextreme.com (http://www.lextreme.com)

Note: The H150/150 and R150/151 are not the same transmissions!

Just my $.02.

[slosurfer]

:good:

[Crinale]

unpossible

haha .. nice chris

to OP, dhc6 is right. 1uz is a LOT of work. I was debating doin this in my 4runner at one point, then i talked to someone who did the swap who said they would not do it again given the chance.