Looks Good Sean,
So does it come in 3 pieces and you weld it together?
Printable View
Looks Good Sean,
So does it come in 3 pieces and you weld it together?
One piece. I was welding on the light tabs to match my light bar.
Why does everything take 5x longer than it should?
Got the turn signals installed on the rack and wired up.
Entered the body through the tailgate harness. I just cut into the plastic and pushed my wire up through then taped it back up. Worked great!
https://farm5.staticflickr.com/4552/...bf4c534e_b.jpg
I tapped the input to the trailer harness for my left and right turn signals. I also ran a wire up for a future 3rd brake light on the rack.
https://farm5.staticflickr.com/4522/...57d7ae15_b.jpg
Used a 4-pin waterproof connector so I can disconnect the rack from the vehicle cleanly.
https://farm5.staticflickr.com/4553/...750ae47c_b.jpg
I still have some wire to clean up but this will get me through the next few months until I can finalize all of the rack wiring.
https://farm5.staticflickr.com/4548/...51c059bd_b.jpg
Lights are plenty bright for daylight and at night really perform.
https://farm5.staticflickr.com/4550/...3c5751ba_b.jpg
Nice looking rack. Great job on the lights as well.
Nice job Sean. It's starting to look more like "your" rig.
Thanks!
Today I put in LED Tail/Brake and Turn bulbs in the rear. Very nice! Pictures are useless for lights. Put in a digital flasher as well. I have on order LEDs for the front, as well as some good halogens for the headlights that will hopefully be better than the HIDs I have in there now. I have new housings waiting for a projector swap, but that is a bit down the road. Probably a good winter project. Or summer...
Unfortunately, none had HID headlights. And the projectors are garbage, even with halogens. 2 dim candles stuck to the front of 5600 pounds