97Limited
very nice, i think you need to make another rear set, so i can test them for ya :D
Printable View
97Limited
very nice, i think you need to make another rear set, so i can test them for ya :D
I agree Ric those look real nice!
A set of them would look sooooooo PURDY on the mall crawler, woohooo, just on the rear, WabFab took care of the front.Quote:
Originally Posted by ecchamberlin
I just started thinking about the rear sway bar links. The fronts I have been taking off all along and have a really quick routine for. It is only 2 nuts/side and I really only have about 2" of lift in the front if that with the saws sagging now.
I was doing some flex posing (avatar) last weekend after a trail run and Noticed that I could get just a bit more our of the rear because the links were obviously holding me up even if just a little.
Hi
can you share with us the parts needed and where to get them?
thanks!
I will figure out part numbers tomorrow or Thursday. This is a pretty old thread and most of these guys aren't active anymore.
Welcome to the forum!
I have no idea what parts 97Limited used. I can get you 2nd gen endlink part numbers as mentioned in the other posts, but I don't think that is what you are actually after.
I am actually in the same boat. I would LOVE to know what he used!