Search:

Type: Posts; User: Nuthuts96; Keyword(s):

Page 1 of 3 1 2 3

Search: Search took 0.01 seconds.

  1. Replies
    6
    Views
    1,261

    Re: Wheel cap paint

    i was so sick of looking at the ugly faded caps, i took 'em off and they've been off for over a year now- the black hubs have grown on me, but may give this a try with the WP101 paint...
  2. Replies
    35
    Views
    4,714

    Re: paddlenbike's maintenance/upgrade log

    just did the brembos w/oem pads on sunday and they are great! had the same conclusion- don't tow much, don't brake hard (use the trans for braking a lot)- they get the job done just fine.
  3. Re: What brake pads do you like for stock rotors ?

    I, too, went Brembo blanks and Hawk LTS. A good chunk of change, but the performance is phenomenal!

    The only (seriously, only) downfall is the dust. These pads produce clouds of dust. For this...
  4. Replies
    20
    Views
    4,046

    Re: Oil Changes: What I've Learned

    x2. crank wheel over and hand tight has only been a problem for me once in 10-15 changes (on cross-country trip, i didn't double check the filter and it was loose and leaking after 2000 miles)....
  5. Replies
    10
    Views
    2,647

    Re: Temperature Control Dial Problems

    sounds like some cables need adjusting, behind the control unit. i think it'd be worth it to dismantle the dash in an attempt to fix the issue. i would.

    i would also make sure this was done near a...
  6. Replies
    31
    Views
    13,976

    Re: 4Runner Steering Rack Replacement

    that's not the update in this thread i wanted to see...
    sorry to hear that. can't you just get new seals and whatnot to replace on the junkyard rack? you'd only be out a weekend if you did the work,...
  7. Replies
    18
    Views
    3,280

    Re: A SC dream come true???

    swap engines, perhaps? it's an expensive investment for sure. one i certainly have "drooled over" but am not in any place to actually bite the bullet... yet :)
  8. Replies
    4
    Views
    1,076

    Re: aftermarket cruise control?

    i've seen places like CARTOYS advertise aftermarket cruise system installations. maybe your local auto electronics installer does the same?

    i imagine retrofitting in the factory system would be...
  9. Replies
    21
    Views
    4,286

    Re: Energy Steering Rack Bushing Kit Tools

    you are right- a 1 5/8" open-ended wrench (which is a MONSTER, by the way) is what i used (it was tight, but i just tapped it onto the tie rod end with a mallet)- borrowed from the heavy-vehicle...
  10. Replies
    21
    Views
    4,286

    Re: Energy Steering Rack Bushing Kit Tools

    wow- the cost of a reman'ed rack is the cost of 2 inner tie rod ends from the local dealer! i could just be worth it... they look so clean and pretty, too!
  11. Replies
    21
    Views
    4,286

    Re: Energy Steering Rack Bushing Kit Tools

    PM'd- the short answer, yes it solved my failed-inspection problem. no new rack necessary.

    if you needed an american shipping address for anything, just give me a holler. the wife and i will be...
  12. Replies
    11
    Views
    1,895

    Re: Assembly line full of 3.4 V6's

    maybe they'll just crush 'em all- would you be surprised? they'll call it the plant closing safety recall... grab me a locker and all the goodies that go with it when they sell 'em, eh? :)
  13. Replies
    6
    Views
    1,443

    Re: how much is my 96 4runner worth?

    thank you but i think ive just about wised up. i got a little wrapped up in the solid axle hype. after some intense reading...my expectations of an mildly modified fj80 going drastically different...
  14. Replies
    41
    Views
    5,917

    Re: Seanz0rz's interior mods

    nice! brings back memories of when i made a console for my '87 pickup after the bench was torn out and replaced with camry buckets. constructed out of 3/4" pine... i, too, had to have cupholders and...
  15. Replies
    8
    Views
    1,370

    Re: Radio Antenna ad nauseum...

    Nice. thanks for the link, Mike. I think my 4' firestik would look funny there...probably not too sturdy either. (Plus, I like where it mounts now in the tailgate gutter.) Yea- I'm thinking I'll just...
  16. Replies
    8
    Views
    1,370

    Radio Antenna ad nauseum...

    SO.... the day has come. I was just thinking the other day, "how lucky am I!? the antenna still works nearly 100% for me..." eating those words now. Got home tonight, shut the truck off, and welcome...
  17. Re: Leaking Upper Ball Joint and Torn Steering Rack Boot

    Ball Joint Question: No clue, doing research too!

    Tie Rod Questions: Two easy answers for two easy questions! :) I think I can handle this one :wrenchin:

    Part Number available at...
  18. Replies
    9
    Views
    2,071

    Re: 100k miles on 4RUNNER

    How do you Like the Brake combo so far? I did this and like it a lot! It squealed right after the job, but an application of brake quiet fixed that right up!
  19. Replies
    15
    Views
    2,607

    Re: Try something for me

    pretty sure when i was coasting down hills (while moving cross-country, with trailer), the rpm's would drop to idle speed at 60mph+ .
    if you're not opening the throttle more (accelerator down),...
  20. Replies
    4
    Views
    1,019

    Re: Crankshaft/Camshaft seals w/ TB change?

    i left the cam pulleys and the crank pulley alone when i did the timing belt last july. i figure i'll deal with the seals next time, behind said parts, right? (along with the idler pulleys). - ok,...
  21. Re: looking to improve the handling and steering...

    [/quote]

    I believe the "polyurethane bushings" they refer to are the sway bar bushings, not the steering rack bushings...i've heard they can be squeaky, and nothing really to do about them except...
  22. Re: looking to improve the handling and steering...

    Poly Bushings tightened things up here! 3/5 wrenches sounds about right. just did it about a month ago (while replacing inner rack end)

    tools needed:
    deep 22mm socket
    deep/shallow 19mm sockets...
  23. Replies
    21
    Views
    4,286

    Re: Energy Steering Rack Bushing Kit Tools

    Got the Kit in today. took a little extra time as i wasn't quite ready...forgot about the necessary wrenches to separate the inner from the outer tie rods. after the tie rod was off, it was just a...
  24. Replies
    21
    Views
    4,286

    Re: Energy Steering Rack Bushing Kit Tools

    sounds like it should be simple! haha...nothing will go wrong.
    i'll be taking off the outer and inner tie rod ends on the driver's side anyway, so that's a plus. what's the reason to disconnect the...
  25. Replies
    21
    Views
    4,286

    Re: Energy Steering Rack Bushing Kit Tools

    thanks! i think i may have that 22mm already.... thought i needed it for something...
Results 1 to 25 of 70
Page 1 of 3 1 2 3