Search:

Oh yeah. They welded up nice and easy. I honestly though it would be hard to get everything uniform but it only took about 20 minutes of fitting, marking, and cutting to get everything right....

Well it finally happened. I ended up getting a new job and along with it came a long commute through to brainless bambi zombie horde territory. I installed it about a month ago but it has served me...

Pause on this item, our offer on a house was just accepted. Doesn't have a garage sadly but it does have space for one in the future.

Sent from my SAMSUNG-SM-G870A using Tapatalk

Yeah when I started piecing together ideas I remembered how easily the crossbeam in the front was bent so I figured that adding a little something might help. But when you hit something that force...

No idea where the factory crush is on the front end and I wasn't aware there was one honestly. All I have on the front of my frame is the two nubs after the crossbar. The crossbar is bent too so I...

Ok progress is really slow when I have to keep teaching myself SolidWorks nearly from scratch again and again but I think I have a component designed fairly well. I wanted to have a crush insert on...

All of those are acceptable as well. I will be looking for the best rate. Thickest metal in my design is 3/16" so plasma will probably be the most economical but different companies have different...

If I can make the measurements and get a reasonable rate for bending a couple of tubes plus some laser table work I will just use my own design.

Sent from my SAMSUNG-SM-G870A using Tapatalk

I was looking for them and I could only find two. Neither were hybrids. I would be very interested in a hybrid that I could just weld up. The savings for the shipping would be nice.

Sent from my...

Well I am planning on smoking another bambi, not because I want to, but because michigan. Since I'm building for running something over at speed that is around 125 or so then I think I'm going to...

This is what I was thinking. But as far as I know bent tube is stronger than cut and welded tube correct? I would have to find a source for the tube bender. There's some fabricators around though.
...

Yes! I knew they would total the 98 and I'd be stuck trying to find a decent michigan frame (which there isn't lol) and basically sol. All said and done I'm up to possibly 500. I'm not sure if my fan...

Well long story short I got one.....not with my AR but with the runner.

Not bad for smoking a deer at 65 or so. Didn't bother to hit the brakes because the damn thing lept into the road right in...