ok, so it looks like my rear diff is leaking a bit after i swapped 3rds, so i've gotta re & re the 3rd. Regarding the mounting studs, how does one remove & replace the ones that are in there (when the nut comes off) and how do you remove the nut off the stud should the two come out together? im thiking if i can get em all out, i'll probably replace all the studs. good idea or no? the leak itself looks to be on the elocker side of things...im guessing that the long stud or one surrounding it is the culprit. might have not been on tight enough? i've gone over each nut and its all good, but if the stud itself isnt in all the way.. could that cause a leak?
also, is it recommended to only use the gasket? or can RTV be used in its place? of course ill surface down the mounting faces so its as smooth & even as possible.
thanks for any input