my swaybar hugs the diff so tight, that you actually have to remove it just to pull the 3rd, maybe the 3rd gen's take into account that some had the elocker and made room for it.
If you could take a pic of your bar that would be sweet.
my swaybar hugs the diff so tight, that you actually have to remove it just to pull the 3rd, maybe the 3rd gen's take into account that some had the elocker and made room for it.
If you could take a pic of your bar that would be sweet.
My signature
haha yea i remember mine being pretty tight, il have to find it, i have NO clue where it is.
2005 Lexus LX470 - Stock for now...
1998 Toyota 4Runner SR5 V6 4x4 + a bunch of goodies. Lifted, Locked, Illuminated and Armored. Winner,"Best Offroad Truck" - 2010 Pismo Jamboree. It's been upside down and still drives me to work.
I found a couple pics online, I just need to snap a pic of mine now. April broke my camera!!!
My signature
Originally Posted by slosurfer
sure you didnt just turn it sideways!!!!!!!!
2005 Lexus LX470 - Stock for now...
1998 Toyota 4Runner SR5 V6 4x4 + a bunch of goodies. Lifted, Locked, Illuminated and Armored. Winner,"Best Offroad Truck" - 2010 Pismo Jamboree. It's been upside down and still drives me to work.
she spiked it like she just scored the winning touchdown
My signature
i love you very much chris...
pending testing, its ready to go!
Last edited by Seanz0rz; 08-25-2013 at 06:52 PM.
2005 Lexus LX470 - Stock for now...
1998 Toyota 4Runner SR5 V6 4x4 + a bunch of goodies. Lifted, Locked, Illuminated and Armored. Winner,"Best Offroad Truck" - 2010 Pismo Jamboree. It's been upside down and still drives me to work.
Sean, you rock!!!
My signature
chris,Originally Posted by slosurfer
my rear sway bar fit w/o any problems. i'm going to the junkyard this weekend, do you want me to get one for you?
bob
Bob, thanks for the offer. I think I'll hold off on it though. I need to look better at mine, I may even be able to use a spacer on mine. I also need to find a 3rd gen to crawl under to see what the differences are as far as mounting, etc...
My signature
I don't have a pic of mine yet, but here is a pic of a 3rd gen:
Top is the OEM and the bottom is an Addco:
The center on mine is shaped like a bell curve instead of going up, flat, then going back down. That's where it runs into a problem, since it doesn't leave room for the actuator.
Sean (or anyone else for that matter), when you find yours, could you measure across from end to end where the links will attach (top on the pic) and across the bottom before it bends up to where the links attach (bottom on the pic from 90* bend to 90* bend).
I'll try to get pics of mine with April's camera.
My signature