It is a plate bumper, with some tube quarter panel protection.
Mounts are 1/4 inch, and the rest of it is going to be 3/16. It will have a hitch receiver and shackle mounts on it when i get done.
How it looks now, its not much but its the hard part to get mounts and the main cross section planned out.
How it is now
Update:
Here is how it sits now, you can get the basics of how its gonna look when its done.
Almost done:
Pretty much done, just got a little tweaking to do.
Looks good! I even helped. haha.
Try to keep this thread more on topinc than the one on the GA TTORA board.
-Chris
2004 DoubleCab Tacoma PreRunner: 3.4 V6-Auto, DD/Tow Rig
1997 Lexus LX450: 4.5 I6-Auto, DD
1984 4Runner: 22R-5 speed, 14 inch bob, 5.29's, lincoln locked rear, lockright front, Armored and Caged by Mossyrocks Fabrication, total disregard for body damage.
1997 4Runner: GONE
1996 FZJ80 Land Cruiser: GONE
Looks good. Looks alot like Bruce's. Does it attach to the frame with bolts? Do you have experience with this design? Does it fill up with mud or debris on the inside? It looks like you'd always have to be cleaning it out and that it would fill up with mud and snow.
The work is excellent as always. Congrats on the new bumper.
96 4Runner SR5 B&M trans cooler, H.I.D conversion
Posting Permissions
Reply With Quote