After seeing a couple of front skid plate designs I've decided to take a stab at one. My factory one is throughly beat and integrity compromised. Because it's all beat up it's hard to get on and off not to mention the holes don't really line up any more.
I've looked at the aftermarket ones and even ones for different vehicles to get ideas. For the most part I think I'll copy them. That's the intent but once I get to cutting we'll find out. I have 2 belly skids and I hope to incorporate them to this new plate.
Here is what I've been using as a belly pan. It hasn't taken too many hits so I think I'm going to trim it up some, maybe add some speed holes. The piece on the very front in this picture is what I made to replace the rear factory section. My new design will replace the 2 front factory pieces.