Ya I need to cut the bottom with a sawzaw. I just havnt figured out a were i want to cut it..or if i want to do it at a angle or straight.
As far as the 60's go, is there anyone in this forum that you know of that would know about 60's?
I am almost positive that te the 61 has a thicker tube width though just by looking at it.
Do you know of a place were you can get stock ford dana HP 60 housings from the manufacturer? I assume that would be signifigantly less than getting a tera 60R housing or some other after market housing. Anhyways thanks for the post...im going to go finish the bobbing.