need f/r 4.56's or 4.88's for a '98 4runner. would prefer front carrier and rear third if possible
need f/r 4.56's or 4.88's for a '98 4runner. would prefer front carrier and rear third if possible
98 runner limited
i got a rear arb 4.88 third that i am going to sell, the gears make a tad bit of noise when the pinion is on the coast side of the gear.
how much and where are you located? i really need to do both f/r at the same timeOriginally Posted by crolison
TOF?Originally Posted by NorCalBorn
98 runner limited
thanks. i think i found them. i sent them both pm's and am waitin on a response. do they deal with new stuff or do you think they might have what i need layin around?
98 runner limited
I my own opinion, and just to ask the question. Why do people buy used gear sets ? I understand the need to save money, but all that bother for a questionable set, is a wonder to me.
On that note I have a set of precision 4.88's I pulled out cause they are funky. You can have em for free. I also have a bunch of used bearings, and crush sleaves.
i hope i dont come off soundin like a dick, but some of us are i situations where we cant just go and spend a grand on gears, intstall kits, and having them put in. i would if i could, but you gotta work with what you have.
98 runner limited
i would like to think that the people you deal with of forums like this, who share the same interests wouldnt f*** you over by selling you something they knew was junk.
on that note.
what did they come out of?Originally Posted by 4runnerchevy
98 runner limited
I was kidding. I sheared a pin on a lunch box (some time ago), and they are toast. I think they would make a good lawn ornament at someones house (not mine).
oh. ok. lol. i dont think thats what im lookin for
98 runner limited
i pm'd you, but if i can sell just the arb. I can send you housing with pinion gear installed and the ring gear and a v6 open carrier. So all you'd have to do is put the carrier in and check the specs (mostly backlash) to get it to work.