Scraps that idea, unless the holes could be welded up and redrilled.Originally Posted by slosurfer
if you wanted the 6 on 5.5 it looks like you would have to make your own.
Looking at probably 200 to get the spindles and hubs plus the cost of steel to make the tube.
I did find this site:
http://www.jeepsonly.com/project1/m416.html
which had some specs, looks like the hubs are 1 3/8" inner and 1 1/16" outer. which are smaller than the 6 on 5.5 hubs inner 1 1/4 Outer Bearing Size (in.) 1 3/4
Then had the idea "use a Toyota rear axle then you'll have all kinds of spare parts".
WRONG.
looks like the trailer is 49" wide, and a rear axle is pushing 58.5"
I would probably do the spacers from Chris and get some wider fenders
http://www.northerntool.com/webapp/w...25?cm_vc=C5503
??