I'm hoping Slacker from Toyota Fiberglass sees this . . .
I was looking at their site just a few days ago and saw that they now have 1st gen 4runner wheel well repair panels in fiberglass for $175/ea . . . I was hoping for a bit more info, pics installed and install instructions. Do they just overlay the existing sheet metal or does the existing 1/4 panel have to be cut?
[img width=800 height=600]http://www.toyotafiberglass.com/4Runner%20wheel%20wells%201.jpg[/img]
I was also wondering if there has been any thought given to making a similar 1/4 panel, but matching the look of the "high clearance" fenders below. In other words, cut out the rear 1/4 and attach the fiberglass to the larger diameter inside the wheel well - with a bit of extended round flare to match these fronts:
[img width=800 height=450]http://www.toyotafiberglass.com/HPIM0037.jpg[/img]
or partial panels with the "Custom 3 Flare 1/4's"