Today I installed a used URD short shifter on my 2000 4runner, while it was apart I also installed a Marlin Crawler shifter seat and socket.
The shorter throws are nice, but I've noticed two problems.
1. It is extremely difficult to get into 1st gear when stopped. I have to put it in 2nd gear first and then use a good amount of force to get into 1st.
2. There is a significant whine in 5th gear at highway speeds when under load. This gets louder as the speed increases, and goes away when I get off the gas and coast.
At this point I'm thinking of going back to the stock setup. But, before I do, does anybody have any input on the above issues? My guess is that for some reason the shifter is not allowing me to get completely into 5th gear. I have the extension fully seated on the stock shifter, so the only thing I can think of is if the extension body is rubbing on something. I did notice that the extension has some wear on the sides from the previous owner, so perhaps it does rub.
- Matt