I am nearly ready to call this quarter panel "DONE!"

This part didn't come out very well:


I will try to stuff the football back in there and see if I can get it pushed out a little bit.

This is still a problem area. I will be looking under the hatch to see how to unweld, pull it out, and reweld. Can't get to it right now, so it will just have to stay for now.

Whole section still doesn't look right:


Not sure what else I can do there, but I don't think I am going to really worry too much. It is still an offroad vehicle.



So as of now the quarter is done. I still have to grind off some stud remnants, hammer down some high spots and get rid of the stud pimples. Also a few holes to weld up. I never did get an answer from Monstaliner concerning coating over bondo and what spray primer is acceptable; looks like some more research for me!

Thanks for the kind words. Pictures don't do the lumpy panel justice. It is still pretty nasty looking, lumpy, and extremely far from perfect.